DataLinkVisualizerEnablingWirelessShowcase

Package: inet.showcases.visualizer.canvas.datalinkactivity

DataLinkVisualizerEnablingWirelessShowcase

network

(no description)

DataLinkVisualizer Ipv4NetworkConfigurator Ieee80211ScalarRadioMedium AdhocHost AdhocHost

Usage diagram

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Properties

Name Value Description
isNetwork
display bgb=700,250

Unassigned submodule parameters

Name Type Default value Description
configurator.minLinkWeight double 1E-3
configurator.configureIsolatedNetworksSeparatly bool false
configurator.config xml xml("")

XML configuration parameters for IP address assignment and adding manual routes
configurator.assignAddresses bool true

assign IP addresses to all interfaces in the network
configurator.assignUniqueAddresses bool true

avoid using the same address and raise an error if not possible
configurator.assignDisjunctSubnetAddresses bool true

avoid using the same address prefix and netmask on different links when assigning IP addresses to interfaces
configurator.addStaticRoutes bool true

add static routes to the routing tables of all nodes to route to all destination interfaces (only where applicable; turn off when config file contains manual routes)
configurator.addDefaultRoutes bool true

add default routes if all routes from a source node go through the same gateway (used only if addStaticRoutes is true)
configurator.addSubnetRoutes bool true

add subnet routes instead of destination interface routes (only where applicable; used only if addStaticRoutes is true)
configurator.addDirectRoutes bool true

add direct routes (i.e. directly connected interfaces) to the routing table (used only if addStaticRoutes is true)
configurator.optimizeRoutes bool true

optimize routing tables by merging routes, the resulting routing table might route more packets than the original (used only if addStaticRoutes is true)
configurator.dumpTopology bool false

print extracted network topology to the module output
configurator.dumpLinks bool false

print recognized network links to the module output
configurator.dumpAddresses bool false

print assigned IP addresses for all interfaces to the module output
configurator.dumpRoutes bool false

print configured and optimized routing tables for all nodes to the module output
configurator.dumpConfig string ""

write configuration into the given config file that can be fed back to speed up subsequent runs (network configurations)
radioMedium.neighborCache.refillPeriod double
wirelessSource.status.initialStatus string "UP"

TODO @signal, @statistic
wirelessSource.pcapRecorder.verbose bool true

whether to log packets on the module output
wirelessSource.pcapRecorder.pcapFile string ""

the PCAP file to be written
wirelessSource.pcapRecorder.fileFormat string "pcapng"
wirelessSource.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
wirelessSource.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
wirelessSource.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*]"

space-separated list of sibling module names to listen on
wirelessSource.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
wirelessSource.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
wirelessSource.pcapRecorder.dumpProtocols string "ethernetmac ppp ieee80211mac"

space-separated list of protocol names as defined in the Protocol class
wirelessSource.pcapRecorder.packetFilter object "*"

which packets are considered, matches all packets by default
wirelessSource.pcapRecorder.helpers string ""

usable PcapRecorder::IHelper helpers for accept packettype and store/convert packet as specified linktype currently available: "inet::AckingMacToEthernetPcapRecorderHelper"
wirelessSource.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
wirelessSource.pcapRecorder.displayStringTextFormat string "rec: %n pks"
wirelessSource.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
wirelessSource.cb.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessSource.cb.forwardServiceRegistration bool true
wirelessSource.cb.forwardProtocolRegistration bool true
wirelessSource.bl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessSource.bl.forwardServiceRegistration bool true
wirelessSource.bl.forwardProtocolRegistration bool true
wirelessSource.li.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessSource.li.forwardServiceRegistration bool true
wirelessSource.li.forwardProtocolRegistration bool true
wirelessSource.eth.bitrate double
wirelessSource.nl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessSource.nl.forwardServiceRegistration bool true
wirelessSource.nl.forwardProtocolRegistration bool true
wirelessSource.tn.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessSource.tn.forwardServiceRegistration bool true
wirelessSource.tn.forwardProtocolRegistration bool true
wirelessSource.at.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessSource.at.forwardServiceRegistration bool true
wirelessSource.at.forwardProtocolRegistration bool true
wirelessDestination.status.initialStatus string "UP"

TODO @signal, @statistic
wirelessDestination.pcapRecorder.verbose bool true

whether to log packets on the module output
wirelessDestination.pcapRecorder.pcapFile string ""

the PCAP file to be written
wirelessDestination.pcapRecorder.fileFormat string "pcapng"
wirelessDestination.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
wirelessDestination.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
wirelessDestination.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*]"

space-separated list of sibling module names to listen on
wirelessDestination.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
wirelessDestination.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
wirelessDestination.pcapRecorder.dumpProtocols string "ethernetmac ppp ieee80211mac"

space-separated list of protocol names as defined in the Protocol class
wirelessDestination.pcapRecorder.packetFilter object "*"

which packets are considered, matches all packets by default
wirelessDestination.pcapRecorder.helpers string ""

usable PcapRecorder::IHelper helpers for accept packettype and store/convert packet as specified linktype currently available: "inet::AckingMacToEthernetPcapRecorderHelper"
wirelessDestination.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
wirelessDestination.pcapRecorder.displayStringTextFormat string "rec: %n pks"
wirelessDestination.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
wirelessDestination.cb.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessDestination.cb.forwardServiceRegistration bool true
wirelessDestination.cb.forwardProtocolRegistration bool true
wirelessDestination.bl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessDestination.bl.forwardServiceRegistration bool true
wirelessDestination.bl.forwardProtocolRegistration bool true
wirelessDestination.li.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessDestination.li.forwardServiceRegistration bool true
wirelessDestination.li.forwardProtocolRegistration bool true
wirelessDestination.eth.bitrate double
wirelessDestination.nl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessDestination.nl.forwardServiceRegistration bool true
wirelessDestination.nl.forwardProtocolRegistration bool true
wirelessDestination.tn.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessDestination.tn.forwardServiceRegistration bool true
wirelessDestination.tn.forwardProtocolRegistration bool true
wirelessDestination.at.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
wirelessDestination.at.forwardServiceRegistration bool true
wirelessDestination.at.forwardProtocolRegistration bool true

Source code

network DataLinkVisualizerEnablingWirelessShowcase
{
    @display("bgb=700,250");
    submodules:
        linkVisualizer: DataLinkVisualizer {
            parameters:
                @display("p=100,50");
        }
        configurator: Ipv4NetworkConfigurator {
            parameters:
                @display("p=100,120");
        }
        radioMedium: Ieee80211ScalarRadioMedium {
            parameters:
                @display("p=100,190");
        }
        wirelessSource: AdhocHost {
            @display("p=300,110");
        }
        wirelessDestination: AdhocHost {
            @display("p=600,110");
        }
}
File: showcases/visualizer/canvas/datalinkactivity/DatalinkVisualizerShowcase.ned

This documentation is released under the Creative Commons license