Crosstalk

Package: inet.examples.wireless.crosstalk

Crosstalk

network

(no description)

IIntegratedVisualizer Ipv4NetworkConfigurator Ieee80211DimensionalRadioMedium AdhocHost AdhocHost

Usage diagram

The following diagram shows usage relationships between types. Unresolved types are missing from the diagram.

Properties

Name Value Description
isNetwork

Unassigned submodule parameters

Name Type Default value Description
configurator.minLinkWeight double 1E-3
configurator.configureIsolatedNetworksSeparatly bool false
configurator.config xml xml("")

XML configuration parameters for IP address assignment and adding manual routes
configurator.assignAddresses bool true

assign IP addresses to all interfaces in the network
configurator.assignUniqueAddresses bool true

avoid using the same address and raise an error if not possible
configurator.assignDisjunctSubnetAddresses bool true

avoid using the same address prefix and netmask on different links when assigning IP addresses to interfaces
configurator.addStaticRoutes bool true

add static routes to the routing tables of all nodes to route to all destination interfaces (only where applicable; turn off when config file contains manual routes)
configurator.addDefaultRoutes bool true

add default routes if all routes from a source node go through the same gateway (used only if addStaticRoutes is true)
configurator.addSubnetRoutes bool true

add subnet routes instead of destination interface routes (only where applicable; used only if addStaticRoutes is true)
configurator.addDirectRoutes bool true

add direct routes (i.e. directly connected interfaces) to the routing table (used only if addStaticRoutes is true)
configurator.optimizeRoutes bool true

optimize routing tables by merging routes, the resulting routing table might route more packets than the original (used only if addStaticRoutes is true)
configurator.dumpTopology bool false

print extracted network topology to the module output
configurator.dumpLinks bool false

print recognized network links to the module output
configurator.dumpAddresses bool false

print assigned IP addresses for all interfaces to the module output
configurator.dumpRoutes bool false

print configured and optimized routing tables for all nodes to the module output
configurator.dumpConfig string ""

write configuration into the given config file that can be fed back to speed up subsequent runs (network configurations)
radioMedium.neighborCache.refillPeriod double
aNode.status.initialStatus string "UP"

TODO @signal, @statistic
aNode.pcapRecorder.verbose bool true

whether to log packets on the module output
aNode.pcapRecorder.pcapFile string ""

the PCAP file to be written
aNode.pcapRecorder.fileFormat string "pcapng"
aNode.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
aNode.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
aNode.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*]"

space-separated list of sibling module names to listen on
aNode.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
aNode.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
aNode.pcapRecorder.dumpProtocols string "ethernetmac ppp ieee80211mac"

space-separated list of protocol names as defined in the Protocol class
aNode.pcapRecorder.packetFilter object "*"

which packets are considered, matches all packets by default
aNode.pcapRecorder.helpers string ""

usable PcapRecorder::IHelper helpers for accept packettype and store/convert packet as specified linktype currently available: "inet::AckingMacToEthernetPcapRecorderHelper"
aNode.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
aNode.pcapRecorder.displayStringTextFormat string "rec: %n pks"
aNode.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
aNode.cb.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
aNode.cb.forwardServiceRegistration bool true
aNode.cb.forwardProtocolRegistration bool true
aNode.bl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
aNode.bl.forwardServiceRegistration bool true
aNode.bl.forwardProtocolRegistration bool true
aNode.li.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
aNode.li.forwardServiceRegistration bool true
aNode.li.forwardProtocolRegistration bool true
aNode.eth.bitrate double
aNode.nl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
aNode.nl.forwardServiceRegistration bool true
aNode.nl.forwardProtocolRegistration bool true
aNode.tn.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
aNode.tn.forwardServiceRegistration bool true
aNode.tn.forwardProtocolRegistration bool true
aNode.at.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
aNode.at.forwardServiceRegistration bool true
aNode.at.forwardProtocolRegistration bool true
bNode.status.initialStatus string "UP"

TODO @signal, @statistic
bNode.pcapRecorder.verbose bool true

whether to log packets on the module output
bNode.pcapRecorder.pcapFile string ""

the PCAP file to be written
bNode.pcapRecorder.fileFormat string "pcapng"
bNode.pcapRecorder.snaplen int 65535

maximum number of bytes to record per packet
bNode.pcapRecorder.dumpBadFrames bool true

enable dump of frames with hasBitError
bNode.pcapRecorder.moduleNamePatterns string "wlan[*] eth[*] ppp[*]"

space-separated list of sibling module names to listen on
bNode.pcapRecorder.sendingSignalNames string "packetSentToLower"

space-separated list of outbound packet signals to subscribe to
bNode.pcapRecorder.receivingSignalNames string "packetReceivedFromLower"

space-separated list of inbound packet signals to subscribe to
bNode.pcapRecorder.dumpProtocols string "ethernetmac ppp ieee80211mac"

space-separated list of protocol names as defined in the Protocol class
bNode.pcapRecorder.packetFilter object "*"

which packets are considered, matches all packets by default
bNode.pcapRecorder.helpers string ""

usable PcapRecorder::IHelper helpers for accept packettype and store/convert packet as specified linktype currently available: "inet::AckingMacToEthernetPcapRecorderHelper"
bNode.pcapRecorder.alwaysFlush bool false

flush the pcapFile after each write to ensure that all packets are captured in case of a crash
bNode.pcapRecorder.displayStringTextFormat string "rec: %n pks"
bNode.interfaceTable.displayAddresses bool false

whether to display IP addresses on links
bNode.cb.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
bNode.cb.forwardServiceRegistration bool true
bNode.cb.forwardProtocolRegistration bool true
bNode.bl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
bNode.bl.forwardServiceRegistration bool true
bNode.bl.forwardProtocolRegistration bool true
bNode.li.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
bNode.li.forwardServiceRegistration bool true
bNode.li.forwardProtocolRegistration bool true
bNode.eth.bitrate double
bNode.nl.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
bNode.nl.forwardServiceRegistration bool true
bNode.nl.forwardProtocolRegistration bool true
bNode.tn.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
bNode.tn.forwardServiceRegistration bool true
bNode.tn.forwardProtocolRegistration bool true
bNode.at.displayStringTextFormat string "processed %p pk (%l)"

determines the text that is written on top of the submodule
bNode.at.forwardServiceRegistration bool true
bNode.at.forwardProtocolRegistration bool true

Source code

network Crosstalk
{
    parameters:
    submodules:
        visualizer: <default(firstAvailableOrEmpty("IntegratedCanvasVisualizer"))> like IIntegratedVisualizer if typename != "" {
            parameters:
                @display("p=100,300;is=s");
        }
        configurator: Ipv4NetworkConfigurator {
            parameters:
                @display("p=100,100;is=s");
        }
        radioMedium: Ieee80211DimensionalRadioMedium {
            parameters:
                @display("p=100,200;is=s");
        }
        aNode[2]: AdhocHost {
            parameters:
                @display("r=,,#707070;p=400,200");
        }
        bNode[2]: AdhocHost {
            parameters:
                @display("r=,,#707070;p=250,200");
        }
}
File: examples/wireless/crosstalk/Crosstalk.ned

This documentation is released under the Creative Commons license